DL AM13 : Ignition System

This Training Software dedicated to the engine starting systems is structured as follows:

CAPIT01.GIF (1491 byte) Ignition technique in Otto cycle engines
  Lesson 1 Ignition in Otto cycle engine  S1301E
Lesson 2 Conventional ignition S1302E
CAPIT02.GIF (1496 byte) Electronics applied to the ignition systems
  LEZI01.GIF (1125 byte) Transistor based ignition S1303e
LEZI02.GIF (1120 byte) Electronic ignition S1304E

 

The Simulation Panel AM13 has been specially designed and realized to allow for a complete and easy learning of the techniques and of the electronic devices used for a correct ignition in Otto cycle engines.
In fact, with the Simulation Panel AM13 it is possible to simulate the following systems:
  • Transistor based ignition controlled through Hall transducer and electronic board for the automatic adjustment of current and closing angle
  • Electronic ignition with transducer of the rpm on the engine shaft and adjustment of the head beat

It can be used by the Teacher for the explanation to the students.
Its dimensions and the completeness of the synoptical panel make it an efficient tool for teaching.

It can be used by students for individual or group studying.
The software and the documentation guide the student to the study and the performance of the simulation exercises.
Furthermore, the Teacher can insert faults in the system and ask the student to perform "Fault Finding" exercises, particularly important for the training of maintenance technicians.